Avaya AP-6 - Manual (Page 235)

Configure Multiple SSID/VLAN/Security Mode Entries
Avaya Wireless AP-4/5/6 User’s Guide 4-137
NOTE:
The ability to configure up to 16 VLAN/SSID pairs and configure a
security mode per SSID is available only for the AP-6, and APs that
have an 802.11a/b/g or 802.11b/g Upgrade Kit installed.
The four primary scenarios for using VLAN workgroups are as follows:
1. VLAN disabled: Your network does not use VLANs, but you can
configure the AP to use multiple SSIDs.
2. VLAN enabled, all VLAN Workgroups use the same VLAN ID Tag
3. VLAN enabled, each VLAN workgroup uses a different VLAN ID
Tag
4. VLAN enabled, a mixture of Tagged and Untagged workgroups
Configure Multiple SSID/VLAN/Security Mode
Entries
Each SSID/VLAN can have its own security mode, so that customers can
have multiple types of clients (non-WEP, WEP, 802.1x, WPA) on the
same system, but separated by VLAN.
NOTE:
You must reboot the AP before any changes to these parameters
take effect.
1. Click Configure > SSID/VLAN/Security > Mgmt VLAN.