Vaisala HMT330 - Manual (Page 103)

Chapter 4 _________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 101
Using Serial Line
Use the serial line command FORM to change the format, and the
command UNIT to select metric or non-metric output units.
FORM
Use the serial line command FORM to select the output quantities and
format for serial line measurement messages.
FORM [x]<cr>
where
x = Formatter string
The formatter string consists of quantities and modifiers. If no formatter
string is entered, the command will display the currently active formatter
string. Note that the hash symbol “#” is shown as a backslash “\” when
viewing the current formatter string.
Example:
>form
3.1 "RH=" RH " " U4 3.1 "T=" T " " U3 3.1 "Tdf=" Tdf " " U3
3.1 "Td=" Td " " U3 3.1 "a=" a " " U7 4.1 "x=" x " " U6 3.1
"Tw=" Tw " " U3 6.0 "H2O=" H2O " " U5 4.2 "pw=" pw " " U4
4.2 "pws=" pws " " U4 4.1 "h=" h " " U7 3.1 "dT=" dT " " U3
\r \n
>
When entering the command, use the abbreviations of the quantities. For
more information on quantities, see Table 3 and Table 4 on page 19.
The modifiers are presented in Table 27 on page 102.