Opening a telnet session (lan/wlan), Figure 59, Opening a serial connection – Vaisala HMT330 User Manual
Page 93
Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 91
0810-070
Figure 59
Opening a Serial Connection
4.
Click the Open button to open the connection window and start
using the serial line.
If PuTTY is unable to open the serial port you selected, it will show
you an error message instead. If this happens, restart PuTTY and
check the settings.
Opening a Telnet session (LAN/WLAN)
NOTE
The instructions below assume that the LAN/WLAN interface on the
transmitter is correctly configured and the network connection is already
done.
1.
Power up the instrument and start the PuTTY application. If your
transmitter acquires a network address using DHCP, wait for a
minute for this to complete, then verify the address from the
transmitter.
2.
In the Session window, select the Telnet connection type.
3.
Enter the IP address of your transmitter in the Host Name (or IP
address) field. Use the default Telnet port 23.