Campbell Scientific AP200 CO2/H2O Atmospheric Profile System - Manual (Page 101)

Appendix G. AC/DC Adapter Kit
The 28549 AC/DC Power Adapter Kit allows an AP200 CO
2
/H
2
O
Atmospheric Profile System to be powered from AC mains power.
To install the 28549 in an AP200 system enclosure, untie the power adapter
output cable and feed it under the tubes below the AP200 pump module.
Position the power adapter on the rubberized tab and secure it with the Velcro
strap as shown in FIGURE G-1.
FIGURE G-1. Installation location of power adapter
Bundle the cable, leaving the connector end free, and tie it down to the ribbon
cable and the green, grounding wires as shown in FIGURE G-2.
FIGURE G-2. Bundled cable of power adapter
Strip the ends of the cable extension 3/8 inch and connect it to the AP200
power input terminals as shown in FIGURE G-3.
G-1