ADC SG-1 User Manual
Page 116
Chapter 7: Second Level Commands
7-36
Example(s)
The system should disable the native-ip enable command in case Native IP capability is not licensed (set to off). The
system should report an operation error with the following message format:
Using the no native-ip enable command
It deletes a native ip enabled configuration.
Usage
no native-ip enable interface [<Ethernet<slot\port> | VLAN <slot\port\identifier> |
ATM <slot\port\sub-interface> | tunnel <tunnel interface id> | l2transport <destina-
tion> <vc-id>
Parameter(s)
<slot\port>
This is the Ethernet slot number (valid number range is 0 to 2). This is the Ethernet port number (1 or 2).
<slot\port\identifier>
This is the Ethernet slot number (valid number range is 0 to 2). This is the Ethernet port number (1 or 2), and VLAN
identifier (valid values are 1 to ?).
<slot\port\sub-interface>
This is the Ethernet slot number (valid number range is 0 to 2), Ethernet port number (1 or 2), and VLAN identifier,
sub-interface (valid number range is 1 to 4095).
<tunnel interface id>
This is the tunnel interface identifier (valid number range is 1 to 300).
<destination>
This specifies the LDP IP address of the remote PE; it must be a valid IP address.
<vc-id>
This is used to assign a VC ID to the virtual circuit between the system and the remote PE.
Host(config)# native-ip enable interface Ethernet 0 \ 1
Host(config)# native-ip enable interface ATM 2 \ 2 \ 43
Host(config)# native-ip enable interface VLAN 0 \ 1 \ 45
Host(config)# native-ip enable interface 0\2
Operation Error:
License is required
Host(config)# no native-ip enable interface
Host(config)# no native-ip enable VLAN 1\1\9