ADC SG-1 - Manual (Page 156)

Chapter 7: Second Level Commands June 30, 2006
7-76 SG1-UM-8500-03
Examples
Trace commands
Usage
Parameters
<default>
System's Default trace setting
<Module>
System's trace log by Module
<Group>
System's trace log by Module
Usage
Parameters
<set-all>
Set all modules back to default
< off >
without trace
< on >
with trace
(config-debug)# event-level default 2 output-device console (cr)
(config-debug)#
(config-debug)# error-level default set-all (cr)
(config-debug)#
(config-debug)# event-level default set-all (cr)
(config-debug)#
(config-debug)# trace
(config-debug)# trace < <default < set-all | off | on > | Module | Group >>
(config-debug)# trace default < set-al | off | on>