Table 7-6. interface atm command parameters -19 – ADC SG-1 User Manual
Page 99
Chapter 7: Second Level Commands
7-19
Table 7-6. interface atm command parameters
Example(s)
After this command is run, the system deletes the ATM interface, as well as all of the enabled applications for this
interface (such as, PPPoE, PVC, PPPoA, etc.).
Usage
no interface atm <slot number>\<port number>\<sub-interface number>
For parameters and examples, refer to
Parameter
Description
Legal values/range
<slot >
PMC slot number
1-2
<port number>
SONET physical port number
1
<sub-interface number>
Sub-interface number
1- 2000
<ppp | routed-bridge |
routed routed-bridge-
ppp>
Sub-interface type
ppp - supporting PPPoE and PPPoA
routed - routing capability only (IP over ATM)
routed-bridge - bridge and routing capability (IP
over Ethernet)
routed-bridge-ppp - bridge and routing
capability (PPP and IP over Ethernet
simultaneously)
(Default value: ppp)
point-to-point |
point-to-multipoint
Network topology type
point-to-point
point-to-multipoint
<ip address>
Interface IP address
IP address
<mask>
Interface mask
Mask
<loopback interface
number>
Loopback interface number
Number
<1500 | 1544>
MTU value
1500, 1544
Host(config)# interface atm 2\1\1 <cr>
Host(config)# interface atm 2\1\1 type routed point-to-point ip 192.168.1.2
255.255.255.0 <cr>
Host(config)# interface atm 2\1\1 type routed-bridge point-to-point loopback 1 <cr>
Host(config)# no interface atm