ADC SG-1 - Manual (Page 97)

June 30, 2006 Chapter 7: Second Level Commands
SG1-UM-8500-03 7-17
[loopback]
Places a logical loopback on the bridge-route interface.
<loopback number>
Numeric value assigned to the bridge-route loopback.
[mtu]
Used to set the interface's Maximum Transmission Unit (MTU) (valid values are 1500 or 1544).
Example(s)
Using the pppoa enable command
This command enables PPPoA negotiation for a specific interface within the system.
Usage
pppoa enable interface <slot number>\<port number\[sub-interface number]>
Before enabling PPPoA, you must configure the correct port and the ATM interface.
Parameter(s)
Table 7-5. pppoa enable interface parameters
Example(s)
Host(config)# interface atm 2 \ 1 \ 1 type bridge-route point-to-point ip
192.168.10.1 255.255.255.0 mtu 1544
Added item
Host(config)#
Host(config)# pppoa enable interface
Parameter Description Legal values/range
<slot> Slot number. 1 - 2
<port number> Physical port number. 1 - 2
<sub-interface number> Sub-interface number. 1- 2000
Host(config)# pppoa enable interface 0 \ 1