Setting the ip address, Setting the ip address -2, Ip a – ADC SG-1 User Manual
Page 32
Chapter 4: Accessing the Command Line Interface
4-2
S
ETTING
THE
IP A
DDRESS
Set the management card IP address, subnet mask, and default gateway (if a gateway exists) to enable
communication with external networks and to enable access to the SG-1 CLI for Telnet sessions.
To set a new IP address and subnet mask for the SCC, do the following.
3
Press ENTER to initiate the terminal session.
4
Enter your user name at the Username: prompt.
5
Enter your password at the Password: prompt.
The system will display the Host> prompt:
Welcome to SG-1 System
Username: technician
Password: *****
Login Successful
Host>
Host> configure terminal
Host(config)# interface ethernet
Step
Action
1
From the Host(config)# prompt, enter the interface command in the following format:
interface ethernet <slot number>\<port number> <ipaddr> <netmask> mode
<ethernet mode> [mtu <1500|1544>]
2
From the Host(config)# prompt, enter the ip default-gateway command in the following format:
ip default-gateway <ipaddr>
3
For this change to become permanent, the user must perform a write memory command from the
Host>
first level prompt to save this change to NVRAM (when the save command is issued, it saves all
systems parameters):
write memory
Step
Action