ADC SG-1 - Manual (Page 83)

June 30, 2006 Chapter 7: Second Level Commands
SG1-UM-8500-03 7-3
B ANNER C OMMAND
Creating a Login Banner
You may create a greeting message or banner, to be displayed on the user's terminal when they log in. The banner
may be a string of up to 32 alphanumeric characters.
To set "Welcome to SG-1" as a banner:
At the second level command prompt, type: banner Welcome to SG-1 (then press ENTER).
Configuring Banner command
Usage
Host(config)# banner <Alpha numeric string>
Parameter
<Alpha numeric string>
It is the Terminal greeting (maximum 32 characters).
Example
E THERNET C OMMANDS
This section contains instructions for configuring service for Gigabit Ethernet cards installed in a SCG1664A/D.
Configuring Gigabit Ethernet ports
Use this command to configure service for Ethernet cards.
Usage
interface ethernet <port> \ <slot> <ip address> <mask> <ethernet mode> (mtu
<1500|1544)>
Parameter(s)
<port>
The port number that you want to configure.
<slot>
The slot number that you want to configure (see table 7-1)<ip address>
The ip address to be assigned to the interface.
<mask>
The valid subnet mask for the configured ip address.
Host(config)# banner command
Host(config)# banner ADC
Host(config)# interface ethernet