Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual - Manual (Page 209)

Rockwell Automation Publication 2080-UM002F-EN-E - December 2013 193
Quickstarts Appendix C
Set Controller Password
In the following instructions, the Connected Components Workbench software
is connected to the Micro800 controller.
1. On the Connected Components Workbench software, open the project
for the target controller.
2. Click Connect to connect to the target controller.
On the Device Details toolbar, roll over the Secure button. The tooltip
message “Set, Change, or Clear Micro800 Controller Password
Protection” is displayed.
IMPORTANT The following instructions are supported on Connected Components
Workbench revision 2 and Micro800 controllers with firmware revision 2.
For more information about the controller password feature on Micro800
controllers, see
Controller Security on page 145 .
IMPORTANT After creating or changing the controller password, you need to power
down the controller in order for the password to be saved.