Run the high speed counter – Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual User Manual
Page 221
Rockwell Automation Publication 2080-UM002F-EN-E - December 2013
205
Quickstarts Appendix C
2.
Next, click the Micro830 controller under the Project Organizer pane to
bring up the Micro830 Controller Properties pane. Under Controller
Properties, click Embedded I/O. Set the input filters to a correct value
depending on the characteristics of your encoder.
3.
Make sure that your encoder is connected to the Micro830 controller.
4.
Power up the Micro830 controller and connect it to your PC. Build the
program in Connected Components Workbench and download it to the
controller.
Run the High Speed Counter
1.
To test the program, go into debug mode by doing any of the following:
• Click Debug menu, then choose Start Debugging,
• Click the green play button below the menu bar, or
• Hit the F5 windows key.