Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual - Manual (Page 66)

52 Rockwell Automation Publication 2080-UM002F-EN-E - December 2013
Chapter 5 Communication Connections
4. Click Advanced Settings to configure advanced parameters.
Configure Ethernet Settings 1. Open your Connected Components Workbench project (for example,
Micro850). On the device configuration tree, go to Controller properties.
Click Ethernet.
ASCII Advanced Parameters
Parameter Options Default
Control Line Full Duplex
Half-duplex with continuous carrier
Half-duplex without continuous carrier
No Handshake No Handshake
Deletion Mode CRT
Ignore
Printer Ignore
Data bits 7, 8 8
Stop bits 1, 2 1
XON/XOFF Enabled or Disabled Disabled
Echo Mode Enabled or Disabled Disabled
Append Chars 0x0D,0x0A or user-specified value 0x0D,0x0A
Term Chars 0x0D,0x0A or user-specified value 0x0D,0x0A