Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual - Manual (Page 231)

Rockwell Automation Publication 2080-UM002F-EN-E - December 2013 215
User Interrupts Appendix D
2. In the User Interrupt Configuration window, configure this POU as a User
Fault routine.
User Interrupt Instructions
STIS - Selectable Timed Start
STI0 is used in this document to define how STIS works.
Instruction Used To: Page
STIS – Selectable
Timed Start Use the STIS (Selectable Timed Interrupt Start) instruction to
the start the STI timer from the control program, rather than
starting automatically. 215
UID – User Interrupt
Disable Use the User Interrupt Disable (UID) and the User Interrupt
Enable (UIE) instructions to create zones in which user
interrupts cannot occur. 216
UIE – User Interrupt
Enable 218
UIF – User Interrupt
Flush Use the UIF instruction to remove selected pending interrupts
from the system. 219
UIC – User Interrupt
Clear Use this function to clear Interrupt Lost bit for the selected
User Interrupt(s). 220
STIS STIS
STIS(name or Pin ID)
or ENO(Pin ID) Enable
IRQType
SetPoint 45638