Metrohm 920 Absorber Module User Manual
Page 39
Advertising
■■■■■■■■■■■■■■■■■■■■■■
4 Installation
920 Absorber Module
■■■■■■■■
31
Port
Install this accessory
1
■
30 cm of the PTFE capillary (6.1803.030) (8-
■
Pressure screw (6.2744.350)
■
Coupling (6.2744.080)
3
FEP tubing M6 for 920, 9 cm (6.1805.040) (8-
For this step you also need:
■
Capillary cutter (6.2621.080)
Connecting port 1
1 Cutting the PTFE capillary to size
■
Cut off a piece from the PTFE capillary that is approx. 30 cm long
using the capillary cutter.
2 Mounting the coupling
6.2744.080
6.2744.350
6.1803.030
■
Push the pressure screw over the end of the PTFE capillary far
enough that a few millimeters of the capillary extend beyond the
tip of the pressure screw.
■
Attach the coupling on the pressure screw and tighten it by hand.
Advertising