4 «ic cap, 1 «ic cap» introduction, 1 login – Metrohm 761 SD Compact IC User Manual
Page 72: 2 user interface, Ic cap, Ic cap» introduction, Login, User interface, Section 4 «ic cap, Ction 4 ), and in addition to the «autodatabase
4 «IC Cap»
761 SD Compact IC / Instructions for Use 8.
761.1043
64
4 «IC Cap»
The 761 SD Compact IC can be operated via «IC Net» (see Section 3)
or «IC Cap». System and method settings can be modified only with «IC
Net». Using «IC Cap» is recommended for day-to-day operation. «IC
Cap» is an interface with a simplified GUI via which it is possible to con-
trol the «IC Net» software.
This Section discusses the most important aspects of operation of the
761 SD Compact IC using the «IC Cap» program. For further details,
please refer to the supplied Administrator Manual «IC Cap 2.0»
(8.110.8313) and the Online Help in the «IC Cap» program.
4.1
«IC Cap» introduction
Operation of program «IC Cap» is described in detailed in the supplied
Administrator Manual «IC Cap 2.0» (8.110.8313). Only fundamental as-
pects for working with «IC Cap» are described below.
4.1.1 Login
You must have logged in with a
User
name and
Password
which are also
listed as users in the installed «IC Net». «IC Net» is reopened with each
measurement started by «IC Cap». Login to «IC Net» is automatic in this
case with the same
User
name and
Password
used by the user for log-
ging in to «IC Cap». This is why the user data for «IC Cap» should corre-
spond to that of «IC Net».
Installation: The first login after installation is made without
User
or
Password
. The Administrator should then be defined on the
General
tab of the
CONFIGURATION
window the first time the program is
launched (see Section 2.12.4).
4.1.2 User
interface
The main window consists of two parts, the
button bar
at the right and a
frame
in the left-hand side of the window. The particular elements in-
cluded in the
button bar
and what elements are displayed in the
frame
depends on whether mode
Manual
or
Queue
is activated in the configu-
ration of «IC Cap» (see Section 4.2).
Button bar
: Determinations can be started/stopped with the buttons. In
addition, the buttons can be used to set what is displayed in the
frame
(sample parameters, chromatogram or results). For detailed informa-
tion, see Administrator Manual «IC Cap 2.0» Section 2.