2 «ic cap» - configuration, 1 predefined configurations, 2 configuration "manual.cfg – Metrohm 761 SD Compact IC User Manual
Page 74: Ic cap» - configuration, Predefined configurations, Configuration "manual.cfg, Ction 4.2 ), Ction 4.2.2 ), Ion 4.2 ). then, in the
4 «IC Cap»
761 SD Compact IC / Instructions for Use 8.
761.1043
66
4.2
«IC Cap» - Configuration
Clicking with the right mouse button (anywhere on the «IC Cap»-
interface) and selecting menu item
Configuration
opens the
CONFIGU-
RATION
window. This is where you make the settings for measure-
ments using «IC Cap».
4.2.1 Predefined
configurations
Two predefined configurations are supplied for operating the 761
SD Compact IC:
manual.cfg
for manual operation
auto.cfg
for automatic operation of the 766 IC Sample Processor
Loading a configuration
During installation, you can select which configuration (
manual.cfg
or
auto.cfg
) is opened the first time the program is launched (see Section
The two predefined configurations are saved in folder
SD Analyzer\Ic
Net\Iccap
. Clicking on the <Read Configuration> button in the Mis-
cellaneous tab in the
CONFIGURATION
window opens this folder (
Ic-
cap
) and you can load a predefined configuration.
The configuration settings set the last time the program was closed are
loaded when you launch the «IC Cap» software.
For a detailed description of the configuration settings, see Administra-
tor Manual «IC Cap 2.0» Section 2.
4.2.2 Configuration
"manual.cfg"
You should load configuration
manual.cfg
for manual control of the 761
SD Compact IC using «IC Cap». If you answered the prompt "Do you
work with 766 IC Sample Processor?” (see Section 2.12.2) with <No>
during the installation process, configuration
manual.cfg
is loaded auto-
matically. Otherwise, you must load it subsequently (see Section 4.2.1).