Arc Machines 307 - Manual (Page 74)

Arc Machines, Inc. Model 307 Orbital Tube Welder Training
Document No. 740096 Chapter 6. Page 18
Rev. A
LOGON/LOG OFF. The Model 307 can be set up to require operator logon
names and passwords and set to one of 3 security levels (Operator, Supervi-
sor, or Programmer). The M 307 comes with the default set to not require
log-in and is set to the Supervisor Level.
If the M 307 is set up to require Log-In, Log-In is accomplished by touching
the LOGON button from the M 307 Opening Screen. Users who have entered
their Logon Name and Password from the Security Administration
screen in System Setup Functions are qualified to log on to the M307.
Users are classified as Programmer (highest level) with access to all the
screens, Supervisor, which has more limited screen access, or Operator
which has access to weld screens and can make adjustments within the Over-
ride limits but can not make permanent schedule changes.
Note that the Logon Name is the Welding Operator I.D. used for weld
documentation and weld logging.
Shutting Down the Model 307 Power Supply:
Close any open screens with the Close button.
Close the Weld Schedule you are using.
If a USB device is in use, touch Stop USB
prior to ejecting the device.
Use the Home button to return to the Home Screen.
Log OFF if Logon was required.
Touch “Shutdown” and wait for the message
“It is now safe to turn off your computer” before
turning the M 307 circuit breaker to the OFF position.
Touch OK
when Logon
and Password
have been
entered.