Dynojet 250i: Installation Guide User Manual
Page 102
Advertising
Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Extended Carriage
3-36
9
Using the hand crank, move the carriage forward until the holes for the rear
carriage clamps are accessible.
10 Attach the two rear carriage clamps to the dyno using the shims, washers, and
bolts removed earlier.
Figure 3-42: Install the Rear Carriage Clamps
carriage clamp
washer
bolt
shim
Advertising
This manual is related to the following products: