Removing the hand crank -43 – Dynojet 250i: Installation Guide User Manual
Page 109
Advertising
A C C E S S O R I E S
Power Carriage
Version 5
Model 200i and 250i Motorcycle Dynamometer Installation Guide
3-43
R
EMOVING
THE
H
AND
C
RANK
1
Loosen the set screw on the hand crank and remove the hand crank.
2
Using a 7/16-inch wrench, remove the two bolts securing the flange bearing.
Figure 3-47: Remove the Hand Crank
bolt
flange bearing
hand crank
Advertising
This manual is related to the following products: