Dynojet 250i: Installation Guide - Manual (Page 62)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Ramp Bracket
2-40
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RAMP BRACKET
The ramp bracket allows you to attach your own ramp to the dyno. You will need to
modify your ramp to secure it to the ramp bracket.
1
With the ramp upside down, center the ramp bracket under the lip at the top of
the ramp.
2 Using the larger holes on the bracket, mark and drill two 3/8-inch holes in the
ramp.
Figure 2-41: Mark and Drill Ramp Bracket Holes
ramp lip
ramp bracket
24 inches