Dynojet 250i: Installation Guide - Manual (Page 177)

S T A N D A R D A N D E X T E N D E D T I R E C A R R I A G E I N S T A L L A T I O N — D I S C O N T I N U E D
Extended Tire Carriage—Discontinued
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
E-9
I NSTALLING THE E XTENDED T IRE C ARRIAGE
1 Slide the extended carriage under the nut block and clamps until the carriage
screw contacts the nut block. Be sure the slide plate is under the rear carriage
clamps.
2 Slide the hand crank onto the end of the carriage screw.
3 Secure the hand crank to the screw shaft by tightening the set screw using a
5/32-inch allen wrench.
4 Using the hand crank, screw the carriage through the nut block.
Figure E-10: Install the Extended Carriage
hand crank
extended carriage