Dynojet 250i: Installation Guide - Manual (Page 36)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-14
4 Remove the four bolts securing the brake to the crate.
5 Determine if the brake is to be mounted on the left or right side of your dyno.
Make the following adjustments to the eddy current brake only if you want
to mount the brake on the opposite side of the dyno that it is currently set
up for.
5a
Move the coupler and key to the other side of the brake.
• To remove the key, use a punch and a hammer to apply pressure in the
direction of the arrows shown in Figure 2-14.
5b Move the retarder connector plates to the other side of the brake.
5c Move the temperature sensor to the other side of the brake.
Figure 2-13: Identifying Left or Right Side Brake Set Up
Figure 2-14: Remove the Key
retarder
connector plates
eddy current brake set up for left side installation eddy current brake set up for right side installation
coupler
temperature
sensor
front of dyno
retarder
connector plates
apply force using
hammer and punch
apply force using
hammer and punch
shaft
key