Dynojet 250i: Installation Guide - Manual (Page 40)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-18
9 Secure the side panels on the eddy current brake to the panels on the dyno using
a 1/4-20 bolt. Do this on each side.
Figure 2-18: Secure the Side Panels to the Dyno
10 Replace the existing set screws on the coupler with the thread-lock set screws
provided.
11 Tighten the coupler set screws.
Figure 2-19: Tighten the Set Screws
EB144
not visible from
this view
brake shaft dyno shaft
set screw