Dynojet 250i: Installation Guide - Manual (Page 184)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
I N D E X
Index-iv
T
technical support 1-3
temperature sensor 2-31
temperature sensor cable 2-30
wiring to breakout board 2-31
testing the dyno 5-11
testing voltages 50 Hz B-9
testing voltages 60 Hz B-4
theta controller
dip switches C-2
installation 2-20
power adjustment C-2
power line frequency C-3
power line voltage C-3
replace fuses 4-11
route control cable 2-20
wiring to breakout board 2-31
tie down straps 1-8
attaching 5-3
tire carriage 5-2
belleville washers E-4
hand crank 2-36, E-3
installation 2-34, E-2
nut block 2-34, E-2
remove from crate 2-2
removing 3-5
screw support bracket E-4
tire lock 2-37, E-5
tire stop 2-37, E-5
tire lock 2-37, 3-37, E-5, E-11
tire stop 2-37, 3-37, E-5, E-11
U
unpacking dyno 2-2
using the dyno 5-11
using the high pressure blowers 4-5
W
warnings vii
weight 1-5
wheel clamp, testing 3-49
width 1-5
WinPEP
finding manuals 3-1
wiring breakout board
jumpers 2-31
pickup card cable 2-31
temperature sensor cable 2-31
theta controller cable 2-31