Dynojet 250i: Installation Guide User Manual
Page 20
Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 1
Dynamometer Specifications and Requirements
1-8
E
NVIRONMENTAL
R
EQUIREMENTS
F
ORKLIFT
R
EQUIREMENTS
You will need to provide equipment capable of lifting a minimum of 1,133.98 kg
(2,500 lbs.) to lift the dyno off the crate and into position in your dyno room. You will
also need a pair of straps capable of supporting 1,133.98 kg (2,500 lbs.) to attach to
the dyno. Dynojet recommends using single loop style straps.
G
ROUND
H
OOK
R
EQUIREMENTS
You may wish to install additional ground hooks (included with your dyno) for
securing the motorcycle. The tie-down loops on the pit covers should work for most
motorcycles. If you are running motorcycles that require a different tie-down location,
mount the ground hooks accordingly.
Note: Tie-down straps MUST pull the motorcycle forward.
Using the ground hooks as a pattern, install the Red Head anchors using the hardware
included with the ground hook kit. Install the Red Head anchors according to the
instructions in Appendix A.
P
HONE
AND
I
NTERNET
A
CCESS
Dynojet recommends you have a phone close to the dyno to call for assistance in an
emergency. You may also wish to contact Dynojet to troubleshoot your dyno.
Internet access on your computer is desirable for contacting Dynojet and
downloading new information and updates.
T
IE
-D
OWN
S
TRAPS
Dynojet recommends using motorcycle tie-down straps for securing the bike on the
dyno. You will need to provide the tie-down straps.
description
specifications
Temperature
operating min./max
10°C/50°C (50°F/122°F)
storage min./max
0°C/60°C (32°F/140°F)
Humidity
0 to 95% non condensing