Dynojet 250i: Installation Guide - Manual (Page 56)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Tire Carriage Installation
2-34
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TIRE CARRIAGE INSTALLATION
Be sure the location you have chosen for your dyno has enough room in front of the
dyno for the maximum extension of the carriage. Refer to “Dynamometer
Specifications and Requirements” on page 1-5 for more information. If you ordered
the extended wheel carriage accessory, refer to “Installing the Extended Carriage
Support Bracket” on page 3-31 and install it at this time.
The tire carriage is fastened to the bottom of the crate next to the dyno. Refer to
step 2 on page 2-2 for instructions on removing the tire carriage from the crate.
If you do not have the standard tire carriage with the bearing bracket, refer to
Appendix D for instructions on installing the standard tire carriage—discontinued.
Note: Before replacing the center panel and installing the tire carriage install the
air hose, the EEC Kit, the door safety switch, and any additional accessories you
may have ordered. Refer to the appropriate sections of this manual for installation
instructions.
1 Replace the center panel using the six 1/4-inch screws you removed. See Figure 2-
2 on page 2-3.
2 Install the three carriage clamps and shims using two 5/16-inch bolts and washers
each.
3 Install the nut block and shim using two 5/16-inch bolts and washers.
Figure 2-35: Install the Carriage Clamps and Nut Block
DC030
carriage clamp
shim
nut block
shim