Dynojet 250i: Installation Guide - Manual (Page 93)

A C C E S S O R I E S
Air Pump and Filter Assembly
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
3-27
4 Remove the two 3/8-inch bolts securing the bracket to the pump assembly and set
the bolts and bracket aside.
5 Remove the pump assembly.
Figure 3-32: Remove the Pump Assembly
6 Remove the four screws securing the pump to the bracket and set aside.
7 Remove the pump from the bracket.
Figure 3-33: Remove the Pump from Bracket
8 Refer to the Air Fuel Ratio Module Installation and User Guide for detailed pump
head maintenance procedures. Failure to follow proper procedures may result in
inaccurate data or damage to the equipment. This manual can be found on your
WinPEP CD or at www.dynojet.com.
pump assembly
bottle bracket
pump
bracket