Dynojet 250i: Installation Guide - Manual (Page 24)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Dyno Installation
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO INSTALLATION
The following directions describe how to unpack, and install your dyno. Follow the
directions in the order that they are presented.
U NPACKING AND I NSPECTING Y OUR D YNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 1,133.98 kg (2,500 lbs.) to move the crated dyno into
position in your dyno room. Refer to “Dynamometer Specifications and
Requirements” on page 1-5 for more information.
1
Remove the crate braces and sides.
Note: At this point, you will want to inspect the exterior of the dyno for any
indications of damage. Report any damage immediately.
2 Remove the tire carriage. The tire carriage is fastened to the bottom of the crate.
3 Remove the support arm. The support arm is fastened to the bottom of the crate.
For more information on the support arm and monitor tray refer to page 2-21.
Figure 2-1: Remove the Tire Carriage and Support Arm from the Crate
tire carriage
support arm