Dynojet 250i: Installation Guide - Manual (Page 170)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
A P P E N D I X E
Standard Tire Carriage—Discontinued
E-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
STANDARD TIRE CARRIAGE—DISCONTINUED
If your tire carriage does not have the bearing bracket, you will need to use the
following directions.
I NSTALLING THE S TANDARD T IRE C ARRIAGE
1 Install the three carriage clamps and shims using two 5/16-inch bolts and washers
each.
2 Install the nut block and shim using two 5/16-inch bolts and washers.
Figure E-1: Install the Carriage Clamps and Nut Block
carriage clamp
shim
nut block
shim