Dynojet 250i: Installation Guide User Manual
Page 88
Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Air Pump and Filter Assembly
3-22
P
ARTS
L
IST
The following table lists all of the parts included in the Air Pump and Filter Assembly
(P/N 64193009 Domestic or P/N 64193010 European) Installation kit. Check your kit
against the parts listed to make sure you have received all of the parts. If any part is
missing, contact Dynojet Technical Support.
I
NSTALLING
THE
F
ILTER
AND
P
UMP
A
SSEMBLIES
1
Remove the cover from the right side of the dyno. Refer to “Remove and Replace
Dyno and Drum Covers” on page 3-3.
2
Remove the four 1/4-inch screws securing the air fuel ratio (AFR) blanking plate to
the dyno and remove the plate. Set the screws aside, they will be used later.
3
Remove the lower two 3/8-inch bolts, washers, and nuts from the lower right
corner of the rear of the dyno and set aside to be used later.
Figure 3-24: Remove the Blanking Plate
part number
description
quantity
21125500
Filter and Sensor Housing
1
21626204
Pump Bracket
1
21696204
Pump Bottle Bracket
1
31991331
1/2” Diameter Rubber Hose
2
34420001
Filter Assembly
1
34491000
Filter Kit Replacement
5
39460210
Drip Bottle, Clear, Plastic
2
43310600
Grommet, 7/16” ID x 3/4” OD
2
64193050
or
64193051
Pump Assembly Replacement, 120V
or
Pump Assembly Replacement, 240V
1
lower bolts,
washers, and nuts
blanking plate