Dynojet 250i: Installation Guide - Manual (Page 42)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-20
I NSTALLING THE T HETA C ONTROLLER
The theta controller is the interface between the eddy current brake and the dyno
electronics. You will only install the theta controller if you ordered an eddy current
brake. You will route the cables to it later. The theta controller is shipped in the eddy
current brake crate.
1
Verify the theta controller dip switch settings. Refer to Appendix C for more
information.
2 Secure the theta controller to the drum module bulkhead using four
8-32 x 3/8-inch screws as shown in Figure 2-21.
Figure 2-21: Installing the Theta Controller
EB146
theta controller
four 8-32 x 3/8 "
screws