Dynojet 250i: Installation Guide - Manual (Page 114)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 3
Wheel Clamp
3-48
4 Bring the wheel clamp cable (three-pin connector) from the front of the dyno
over to the wheel clamp. This cable was routed on page 2-32.
5 Install the wheel clamp cable strain relief to the side of the wheel clamp.
6 Plug the wheel clamp cable into the connector on the wheel clamp motor.
Figure 3-53: Install Wheel Clamp Strain Relief
7 Replace the wheel clamp cover.
Figure 3-54: Replace the Wheel Clamp Cover
WC005A
strain relief
wheel clamp cable
WC006A
cover