Dynojet 250i: Installation Guide - Manual (Page 30)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Dyno Installation
2-8
R OUTING THE P OWER C ABLE
1 Locate the power cable inside the dyno.
2 Slide the strain relief on the power cable through the opening in the dyno frame.
3 Tighten the jam nut.
4 Hand tighten the knurled nut.
Figure 2-8: Route the Power Cable
strain relief around
power cord
jam nut
inside dyno
opening in
dyno frame
knurled nut
outside dyno
cut away view from
inside dyno