Dynojet 250i: Installation Guide - Manual (Page 14)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 1
Introduction
1-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Before installing your dyno, please take a moment to read this guide for installation
instructions, dyno features, and other important information.
This guide is designed to be a reference tool in your everyday work and includes the
following chapters and information:
S PECIFICATIONS AND O PERATING R EQUIREMENTS
This chapter describes the requirements and specifications for the dyno.
I NSTALLATION
This chapter describes the procedures for installing the dyno.
A CCESSORIES
This chapter lists each dyno accessory alphabetically and describes the procedures for
installing and using the accessory.
C ONTROL P ANEL I NTERFACE O PERATION
This chapter describes the control panel interface (CPI) operating procedures.
B ASIC D YNO O PERATION
This chapter describes basic dyno operating procedures.
R ED H EAD I NSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
P OWER R EQUIREMENTS
This appendix describes the power requirements and installation instructions for all
locations.
T HETA C ONTROLLER
This appendix describes how to make power adjustments to the theta controller.
EEC K IT
This appendix describes the procedures for installing the EEC finger guards and door
safety switch.
S TANDARD A ND E XTENDED T IRE C ARRIAGE I NSTALLATION —D ISCONTINUED
This appendix describes the procedures for installing the standard and extended tire
carriage without the easy removal bracket.