Dynojet 250i: Installation Guide - Manual (Page 17)

S P E C I F I C A T I O N S A N D O P E R A T I N G R E Q U I R E M E N T S
Dynamometer Specifications and Requirements
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
1-5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNAMOMETER SPECIFICATIONS AND REQUIREMENTS
The following specifications and requirements will help you set up your dyno area
and verify you have the requirements to operate your dyno safely.
B ATTERY R EQUIREMENTS
Your 200i/250i dyno is designed to carry a group 24 deep-cycle discharge series
battery for operating the starter, power carriage, and optional wheel clamp. The
typical dimensions for this series of batteries are 27 cm long by 17 cm wide by 23 cm
tall (10.625-inches by 6.75-inches by 9.125-inches). The mounting is flexible so a
battery that has dimensions close to this will work satisfactorily. The built-in battery
cables are configured for top-post batteries. This battery is not included with your
dyno. You will need to provide this battery. For more information on installing the
battery, refer to “Installing the Battery” on page 2-10.
C HASSIS S PECIFICATIONS
description specifications
Length
with standard carriage allow 271.78 cm (107.00 inches)
with extended carriage allow 322.58 cm (127.00 inches)
Height
to top of dyno cover 45.97 cm (18.10 inches)
Width
model 200i 106.68 cm (42.00 inches)
model 250i 179.60 cm (70.71 inches)
Weight
model 200i dyno/crated dyno 725 kg (1600 pounds)/771 kg (1700 pounds)
model 250i dyno/crated dyno 1,077.28 kg (2,375 pounds)/1,133.98 kg (2,500 pounds)
Drum
diameter 45.72 cm (18.00 inches)
width 50.80 cm (20.00 inches)
Frame structural steel channel and angle
Maximum Speed 322 KPH (200 MPH)
Maximum Motorcycle Length (front of
front wheel to center of rear wheel)
standard carriage 213 cm (84.00 inches)
extended carriage 256.54 cm (101.00 inches)
Remote Switches remote software control