Installing the temperature sensor – Dynojet 424x: Installation Guide User Manual
Page 100
Advertising
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 4
Eddy Current Brake Installation
4-8
I
NSTALLING
THE
T
EMPERATURE
S
ENSOR
Use the following instructions to secure the temperature sensor to the eddy current
brake in the location shown.
You will need the following part:
• 76955001
Temperature Sensor Assembly
Figure 4-7: Temperature Sensor Location
1
Remove the nut from the sensor.
2
Slide the sensor through the cross brace.
3
Secure the sensor to the brace using the nut removed earlier.
Note: For clarity, the side panel has been removed.
Figure 4-8: Install the Temperature Sensor
temperature sensor
sensor
remove nut
nut
cross brace
Advertising
This manual is related to the following products: