Hydraulic movement installation – Dynojet 424x: Installation Guide User Manual
Page 62
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Hydraulic Movement Installation
3-24
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HYDRAULIC MOVEMENT INSTALLATION
Use the following instructions to install the hydraulic movement.
You will need the following parts:
• 26100000
Spacer,424 Hydraulic Movement (2)
• 32900000
Clevis Pin, 3/4 x 4.5" (2)
• 32904080
Hairpin Cotter, 7/16 x 3/4" (2)
• 36582471
Bolt, 3/8-16 x 1.5", Flange-Hex (2)
• 37513200
Anchor, Redhead, 3/8" (2)
• 61300016
Cylinder Mount, Dyno
• 61300061
Cylinder Mount, Floor
• DM150-011-002
Washer, 3/8", Flat (4)
• DM150-019-012
Bolt, 3/8-16 x 1", Hex (4)
1
Secure the dyno cylinder mount to the dyno using two 3/8-16 x 1.5-inch bolts.
Figure 3-14: Secure the Dyno Cylinder Mount to the Dyno
AD346
dyno cylinder mount