Installing the side deck assembly – Dynojet 424x: Installation Guide User Manual
Page 121
Advertising
S I D E D E C K A S S E M B L Y I N S T A L L A T I O N
Side Deck Installation
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
5-3
I
NSTALLING
THE
S
IDE
D
ECK
A
SSEMBLY
1
Lay the platform assembly on it’s side.
2
Secure the two front step leg assemblies to the platform using two 3/8-16 x 3-inch
hex bolts, four 3/8-inch flat washers, two 3/8-inch lock washers, and two 3/8-inch
nuts each.
3
Secure the two back leg assemblies to the platform using two 3/8-16 x 3-inch hex
bolts, four 3/8-inch flat washers, two 3/8-inch lock washers, and two 3/8-inch nuts
each.
Figure 5-1: Install the Front and Rear Leg Assemblies
AD074
front leg assembly
rear leg assembly
platform assembly
Advertising
This manual is related to the following products: