Dynojet 424x: Installation Guide - Manual (Page 78)

Above Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 3
Bridge Installation—4WD Dyno
3-40
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BRIDGE INSTALLATION—4WD DYNO
This section will walk you through installing the drum guards, runner mounts, runner
assemblies, cover, and runner tie straps.
You will need the following parts:
• 21214701 Runner Tie Strap (2)
• 21214702 Runner Clamp, Short (2)
• 21214705 Runner Tie Slide (2)
• 21216101 Drum Guard, Right
• 21216102 Drum Guard, Left
• 21216103 Drum Guard, Left/Right (2)
• 21219512 Moveable Cover
• 21514801 Runner Mount, Short (2)
• 36561045 Screw, 1/4-20 x 5/8", PH, Torx, Black (14)
• 36582034 Bolt, 3/8-16 x 1.25", Button-Head, Flange, Allen (4)
• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (6)
• 36588071 Bolt, 3/8-16 x 5", Black Oxide (14)
• 36923100 Washer, 3/8", Hardened, Flat, Steel (14)
• 36932100 Washer, 3/8", Splitlock, Steel (14)
• 61319500 Runner Assembly (14)
• DM150-011-004 Nut, 3/8-16, Hex (14)