Dynojet 424x: Installation Guide User Manual
Page 159
Advertising
S T A T I O N A R Y D Y N O U P G R A D E
Deck Relocation
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C-7
3
Remove the center bolt securing the center panel to the dyno and set aside.
4
Remove the six 1/4-20 x 5/8-inch screws and six crush nuts securing the center
panel and supports to the outer panels and set aside.
5
Remove the six 1/4-20 x 5/8-inch screws and six crush nuts securing the center
panel to each support and set aside.
6
Remove the center panel and supports and set aside.
Figure C-6: Remove the Center Panel
AD099
center panel
outer panel
support
center bolt
Advertising
This manual is related to the following products: