Dynojet 424x: Installation Guide User Manual
Page 95
Advertising
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake Installation
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
4-3
B
EFORE
I
NSTALLING
THE
E
DDY
C
URRENT
B
RAKE
: V
ERIFY
M
OUNTING
H
OLES
Dynos with the serial number 2240308 and lower will need to have mounting holes
drilled into the dyno frame before installing the eddy current brake.
Using a 5/8-inch or 1/2-inch drill, mark and drill the four holes as shown in Figure 4-2.
Figure 4-2: Eddy Current Brake Mounting Holes
1.59 cm
(0.625 in.)
6.67 cm
(2.625 in.)
24.13 cm
(9.50 in.)
36.83 cm
(14.50 in.)
60.96 cm
(24.00 in.)
1.59 cm
(0.625 in.)
Advertising
This manual is related to the following products: