Rotating the hydraulic motor – Dynojet 424x: Installation Guide User Manual
Page 66
Advertising
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Hydraulic Movement Installation
3-28
R
OTATING
THE
H
YDRAULIC
M
OTOR
Before rotating the hydraulic motor, verify the motor is wired for your needs. The
motor is wired for 110v but can be changed to 220v.
1
Remove the wiring box cover.
2
Follow the instructions on the cover to wire the motor for 220v.
3
Remove the four bolts and washers securing the motor.
Figure 3-18: Removing the Hydraulic Motor
AD486
motor
wiring box cover
Advertising
This manual is related to the following products: