Installing the cover and runner tie straps – Dynojet 424x: Installation Guide User Manual
Page 82
Advertising
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Bridge Installation—4WD Dyno
3-44
I
NSTALLING
THE
C
OVER
AND
R
UNNER
T
IE
S
TRAPS
1
Secure the cover to the runner mounts using the two reserved bolts from earlier.
2
Secure the cover to the runner assemblies using two 1/4 x 5/8-inch torx head
bolts.
3
Secure one runner tie strap and one plastic runner tie slide to each set of
moveable runner assemblies using six 1/4 x 5/8-inch torx head bolts each.
Figure 3-31: Install the Cover and Runner Tie Straps
AD498
1/4 x 5/8-inch torx
head bolt
cover
reserved bolts
runner tie strap
runner tie slide
Advertising
This manual is related to the following products: