Installing the eddy current brake – Dynojet 424x: Installation Guide User Manual
Page 48
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 3
Dyno Installation
3-10
5
Secure the rail clamps to the cradle assembly on the dyno using two 3/8-inch
shoulder bolts and two spacers each.
6
Replace the pins and cotter pins removed earlier from the four cradle assemblies
as shown in Figure 3-5.
7
Move the rail clamps up and down and verify they move freely.
8
Roll the dyno back and forth and verify the rail clamps are not binding and the
track assembly is square.
Note: For clarity, the stationary dyno is not shown.
Figure 3-6: Secure the Dyno to the Rail Clamps
I
NSTALLING
THE
E
DDY
C
URRENT
B
RAKE
Refer to Chapter 4 for eddy current brake installation instructions and install your
eddy current brake at this time.
AD353
spacer
bolt