Dynojet 424x: Installation Guide - Manual (Page 11)

Above Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
1-1
C
H A P T E R
1
S
PECIFICATIONS AND
O
PERATING
R
EQUIREMENTS
Thank you for purchasing Dynojet’s Above Ground Model 424x/424xLC 2 Automotive
Dynamometer (dyno). Dynojet’s software and dynamometers will give you the power
to get the maximum performance out of the vehicles you evaluate. Whether you are
new to the benefits of a chassis dynamometer or an experienced performance leader,
the repeatability and diagnostic tools of WinPEP 7 software and a Dynojet
dynamometer will give you the professional results you are looking for.
This document provides instructions for installing the stationary dyno, the four wheel
drive (4WD) dyno, and the eddy current brakes. This document will walk you through
operating requirements, hardware installation, electronics set up, and basic dyno
operation. To ensure safety and accuracy in the procedures, perform the procedures
as they are described.
Document Part Number: 98210109
Version 8
Last Updated: 01-25-13
This chapter is divided into the following categories:
• Introduction, page 1-2
• Dynamometer Specifications and Requirements, page 1-4
• Model 424 Stationary and 4WD Dynamometer, page 1-10
• Model 424 4WD Dynamometer with Bridge and Deck, page 1-11
• Dyno Electronics, page 1-12
• Lift Specifications and Requirements, page 1-13