Torque module installation, Installing the torque module – Dynojet 424x: Installation Guide User Manual
Page 108
Advertising
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 4
Torque Module Installation
4-16
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TORQUE MODULE INSTALLATION
This section describes how to install the Torque Module(s), connect the load cell
cable, and install the side and top brake covers.
I
NSTALLING
THE
T
ORQUE
M
ODULE
You will need the following part:
• 66104001
Torque Module
1
Verify the main dyno power is disconnected.
2
Turn off the main power switch on the CPU Module and unplug the power cord.
3
Remove the dust cover from the existing top module.
Figure 4-18: Disconnect Power and Remove the Dust Cover
HS039
dust cover
power cord
input
power switch
Advertising
This manual is related to the following products: