Installing the eddy current brake – Dynojet 424x: Installation Guide User Manual
Page 103
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake Installation
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
4-11
I
NSTALLING
THE
E
DDY
C
URRENT
B
RAKE
You will need the following parts:
• 36708100
Nut, 1/2-13, Nylock-Hex (4)
• 36801080
Bolt, 1/2-13 x 1.5", Flange-Hex (4)
• 36923100
Washer, 3/8", Hardened, Flat (8)
• 36943102
Washer, 1/2", Hardened, Flat (4)
• 37620844
Woodruff Key, 1/2 x 2.75"
• DM150-019-012
Bolt, 3/8-16 x 1", Hex (8)
1
Place the key in the eddy current brake shaft keyway.
2
Place the keyed yoke onto the eddy current brake shaft.
3
Line up the eddy current brake yoke with the driveline assembly.
4
Slide the brake frame towards the dyno frame until they touch. Make sure the
brake yoke is aligned with the driveline.
Note: The stiffener plate lip slides under the dyno frame.
Figure 4-11: Install the Brake Assembly
yoke
driveline assembly
stiffener plate lip
place key in
keyway