Verifying the saar brake pressure – Dynojet 424x: Installation Guide User Manual
Page 136
Advertising
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C H A P T E R 6
Preventative Maintenance
6-12
V
ERIFYING
THE
SAAR B
RAKE
P
RESSURE
1
Verify the SAAR brake pressure gauge reads 100psi (690kPa).
2
Using the knob, adjust the regulator until the correct pressure is achieved.
Figure 6-6: Verify the SAAR Brake Pressure and Adjust the Regulator
AB096
use the knob to adjust the
regulator until the correct
pressure is achieved
brake pressure
regulator
0
AB095
brake pressure gauge
should read 100psi
(690kPA)
Advertising
This manual is related to the following products: