Dynojet 424x: Installation Guide - Manual (Page 44)

Above Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 3
Track Assembly
3-6
I NSTALLING THE T RACK A SSEMBLY
Once all the holes are marked and drilled, install the track assembly.
You will need the following parts:
• 21514282 Rail (2)
• 21716400 Rail Tie (3)
• 31619500 Rail Clip (10)
• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (10)
• 61314300 Rail Tie Assembly (2)
• 61314700 Rail Clamp (4)
1 Layout the first and last rail tie assemblies and the rail ties. Use the holes you
marked and drilled for placement of the rail tie assemblies and rail ties.
Note: The first rail tie has four holes for securing the cable track assembly. Verify
this rail tie assembly is closest to the stationary dyno.
2 Place the rail clamps over the rails.
3 Place the rails into the rail tie assemblies.
Note: For clarity, the stationary dyno is not shown.
Figure 3-2: Install the Track Assembly
AD045
rail clamps
rail
first rail tie
assembly
last rail tie
assembly
rail tie
holes for cable
track assembly